zahir.rawat
New member
hi Guys.. my speedOmeter on my FX160 stoped working..just stays on 0 (zero) the hours & batt volts work, but not the Speed..could it be a fuse? or a lose wire? any suggestions..
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Yamaha FX SpeedOmeter
- Thread starter zahir.rawat
- Start date
zahir.rawat
New member
@ preggieG, thanks for the phone call and all the Advise..much appreciated .. looked for the wheel, but cudnt find it..until mikeF explaind...thanks again
@ MikeF..on the Button Buddie, Awwwsum advise ..thanks Again, felt like a grain of sand was jus holding the wheel from spinning..thanks again..would u recommend i spray it with silicon to make it Run free & smooth??
how's the fishing Been? any luck lately??
@ MikeF..on the Button Buddie, Awwwsum advise ..thanks Again, felt like a grain of sand was jus holding the wheel from spinning..thanks again..would u recommend i spray it with silicon to make it Run free & smooth??
how's the fishing Been? any luck lately??
Ive never heard of lubing it with silicone or something. What generally happens is it clogs up when you beach. What you should do when you launch is get the ski into the water and before you even start the engine up, bounce the back up and down in the water. This not only helps get sand out of the intake thus saving your impeller but helps keep the speedo wheel free of sand as well.