small vs large guides

TankEvans

New member
Hi guys_seal1_

I have a question I can't get much info on.

Whats sthe pro and cons of small guides on a rod vs larger guides?
Im talking specifically for coffee grinder reels here.

I have noticed that some spinning rods like the assasin range come with very small guides whereas other spinning rods like the penn prevail come with large guides...

What's the reason for this? ::tight:
 

Enigma

Moderator
Here is a lot of reading material

http://www.sealine.co.za/view_topic.php?id=90983&forum_id=25

There are some videos to read in there as well.

In short it's all about casting concepts. Many subscribe to old school cone of flight where many of us prefer New Guide Concept (NGC) using coil reduction and straight running guides

What amazes me is the Assassin spinning rods follow NGC and Assassin large bait fishing rods using Grinders follow NGC

https://www.youtube.com/watch?v=sUrUWofrmM8
 

willem wikkel spies

Moderator
Staff member
jus to add something here.

the smaller the guides, the lighter the rod tip section will be.
also much more responsive.

the bigger the guides, the heavier the rod tip section is and the slower the tip response.

yes they tend to become very technical.

my opinion:
the down side to micro guides is that the rod is made for braided lines only and not mono.
 

Sarasin3

New member
I have a BlueMarlin Magnaflex Surf rod and use a Penn Battle 2 8000 grinder with it.

I have 50lb braid on it with about 5m of mono leader.
I use the FG knot to connect the braid and mono.

The rod has the small guides at the top and as said above, it very responsive.

I have been told that I will pick up issues due to using a grinder with this rod.

So far, I have had a couple wind knots but overall, its been really OK. I am getting the same distance if not a bit more now that I am using braid (was using mono before).

Is it wrong to use this combo together? I am guessing no...and if it works it works right?

Are their any cons I am facing with this setup that I might not have encountered yet?

Sorry for the hijack, but the topic got me questioning my setup again.

:)
 

Enigma

Moderator
Length of rod..... I expect it will be 3.6m ie 12' or longer.

Laying the rod out correctly with Low rider guides will not only virtually eliminate line wraps but guarantee an increase in casting distance of no less than 15%

You should however compare Apples with Apples when comparing mono to braid casting distances.

If you were using the rod with 0.45mm mono then compare it's casting distance with 25lbs braid and not 50lbs braid or conversely compare 50lbs braid casting ability with 0.65mm mono.
 

Sarasin3

New member
Cheers!

Its a 13 footer.

Do you think it would be a better idea to have new guides installed or just get a new rod?

I am not sure what it will cost to get new guides fitted. Any ideas on cost?

I am in the Gordons Bay\ Strand area.

Also, does one get a 13ft surf rod with low rider guides already installed in the shops?
If so, could you give me some names I should look into?

Thanks!
 

Enigma

Moderator
Unfortunately our commercial R&S suppliers still stick to the old school and are about 15 years behind on tech of rod guides.

Not because they don't know better but because they supply what public demand is and for now that is still a Flip up guide.

Depending on what guides you are going to use re-doing the old rod is always the best option...... If you get a new rod the one currently being used will just go into retirement.

New custom grinder rod, anything from R2000-4500 and re-doing your current one anything from R600-1200
 
Top