bambooskollie
Sealiner
https://www.youtube.com/watch?v=CN3tooaIGF4
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Stripper/reduction guide
- Thread starter bambooskollie
- Start date
Microwave spinning guide.
It works very much on the same principles as the Fuji Casting concept but with further reduction of the coils.
Cannot / Should not be used with leader systems.
Is being used on the newest models of the Assassin Amia
I personally find it great in rods using braid only setups and then 8' and less in length. Personally I love my leaders so stick with my Low Riders where even a #8 easily facilitates casting a full 0.60mm nylon leader
It works very much on the same principles as the Fuji Casting concept but with further reduction of the coils.
Cannot / Should not be used with leader systems.
Is being used on the newest models of the Assassin Amia
I personally find it great in rods using braid only setups and then 8' and less in length. Personally I love my leaders so stick with my Low Riders where even a #8 easily facilitates casting a full 0.60mm nylon leader
bambooskollie
Sealiner
Evening S,
Setting up guides on a rod is determined by many factors.
Im not an authority on the matter so I will try point you in the right direction...
A good staring point would be here - read from start to finish, it helps to have a blank rod and the right guides to be interactive with this material.
Tape on the guides and go test cast, its a long process but fine tuning will deliver the best results.
http://anglersresource.net/GuidePlacementSoftware.aspx
Setting up guides on a rod is determined by many factors.
Im not an authority on the matter so I will try point you in the right direction...
A good staring point would be here - read from start to finish, it helps to have a blank rod and the right guides to be interactive with this material.
Tape on the guides and go test cast, its a long process but fine tuning will deliver the best results.
http://anglersresource.net/GuidePlacementSoftware.aspx